Effect of phosphogypsum on saline-alkalinity and aggregate stability of bauxite residue

A column experiment was conducted to investigate the effect of phosphogypsum (PG) on the saline- alkalinity, and aggregate stability of bauxite residue. Results showed that: with increasing leaching time, the concentrations of saline-alkali ions decreased while the concentration increased in bauxite residue leachate; compared with CK (control group) treatment, pH, electric conductivity (EC), exchangeable sodium percentage (ESP), sodium absorption ratio (SAR), and exchangeable Na⁺ content of bauxite residue were reduced following PG treatment; average particle sizes in aggregates following CK and PG treatments were determined to be 155 and 193 nm, respectively. SR-μCT test results also confirmed that bauxite residue following PG treatment acquired larger aggregates and larger pore diameter. These results indicate that the PG treatment could significantly modulate the saline-alkalinity, and simultaneously enhance aggregate stability of bauxite residue, which provides a facile approach to reclaim bauxite residue disposal areas.     

全尾砂和废石联合胶结充填体最佳配比及应用

针对红岭铅锌矿分级充填骨料来源不足、地表废石堆积污染环境的情况,提出将该矿选厂产生的全尾砂和地表废石作为充填骨料的联合胶结充填方案。分别测试了全尾砂和地表废石的物理化学性质,验证了碎石和全尾砂作为联合充填骨料的可行性。通过充填配比试验,分析了不同配比全尾砂废石充填体强度特性,得出了最佳充填配比。结果表明,充填试块的强度随灰砂比减小而减小,随养护龄期增加呈增大趋势,随充填料浆质量浓度增大而增大,最佳配比为: 胶结充填灰砂比1∶8、普通充填灰砂比1∶12,全尾砂∶废石配比4∶6,质量浓度78%。根据研究结果,在红岭铅锌矿进行了全尾砂废石充填技术工业应用,证实该技术可行。     

人工砂混凝土性能试验研究

采用正交试验方法配制了不同人工砂取代率、石粉含量、粉煤灰含量的混凝土, 对比了每组混凝土的坍落度, 研究了3 d、28 d龄期混凝土的抗压性能。结果表明: 最优配比的人工砂取代率、石粉含量和粉煤灰含量分别为10%、3%和5%, 此时28 d抗压强度为40.1 MPa, 满足30 MPa的混凝土设计强度。     

Low-cost and two-cycle hardware structures of PRINCE lightweight block cipher

In this paper, low-cost and two-cycle hardware structures of the PRINCE lightweight block cipher are presented. In the first structure, we proposed an area-constrained structure, and in the second structure, a high-speed implementation of the PRINCE cipher is presented. The substitution box (S-box) and the inverse of S-box (S-box⁻¹) blocks are the most complex blocks in the PRINCE cipher. These blocks are designed by an efficient structure with low critical path delay. In the low-cost structure, the S-boxes and S-boxes⁻¹ are shared between the round computations and the intermediate step of PRINCE cipher. Therefore, the proposed architecture is implemented based on the lowest number of computation resources. The two-cycle implementation of PRINCE cipher is designed by a processing element (PE), which is a general and reconfigurable element. This structure has a regular form with the minimum number of the control signal. Implementation results of the proposed structures in 180-nm CMOS technology and Virtex-4 and Virtex-6 FPGA families are achieved. The proposed structures, based on the results, have better critical path delay and throughput compared with other's related works.     

控制反转技术分析

轻量级容器的解耦模式被称为“控制反转”或者“依赖注入”,组件之间的依赖关系由容器(运行环境)在运行期决定,从而在相当程度上降低了组件之间的耦合。该文详细论述了这种解耦模式的原理,以及依赖注入的3种主要形式,并且对几种形式进行了对比总结。     

粉煤灰超细玻珠复配轻集料在固井低密度水泥浆中的作用

阐述了粉煤灰超细玻珠复配轻集料在固井低密度水泥浆中对其流变性能、强度、质量均匀性以及密度的影响和作用机理。表明该复配轻集料可以明显改善水泥浆的流动性、保水性以及水泥与高效外加剂的相容性,水泥石抗压和抗折强度有显著改善,水泥浆具有良好的质量均匀性,用该集料配制的超低密度水泥浆能满足固井要求,并由此提高固井的经济性。     

特细砂混凝土的应用及其经济性

通过介绍特细砂混凝土在嘉陵江流域的马回、东西关、桐子壕等水电站建设中的应用情况 ,分析了特细砂混凝土的特性和配合比等特点 ,并闸明了在施工中使用特细砂混凝土的经济效益。     

大掺量粉煤灰轻质墙体砌块的研制

大掺量粉煤灰轻质墙体砌块是以粉煤灰为主要原材料 ,普通硅酸盐水泥为胶凝材料 ,配以各种外加剂 ,经发泡剂发泡 ,在常温、常压条件下养护而成。具有重量轻、导热系数小、抗冻性高以及粉煤灰掺量大、成型方便、工艺简单、投资小、见效快等优点。     

绿色再生混凝土利用途径与评定思路

就再生混凝土骨料进行深入系统的研究 ,建立了一套与现行评价天然骨料标准相一致的评定方法 ,具有工程实际意义 ,为将来实际应用作好了基础理论研究     

用碳化养护电弧熔炉钢渣制备集料和混凝土

将电弧熔炉(electric arc furnace,EAF)钢渣和石灰混和制成球状集料,置于密闭容器当中,并通入100%的CO2气体进行碳化,在0.506 6MPa保持2h.通过质量法测定添加质量分数为11.94%石灰的EAF钢渣(下同)集料CO2的吸收率为5%,通过红外光谱(infrared,IR)分析测定CO2的吸收率为13.88%.用碳化的钢渣集料制备混凝土再进行碳化养护,同时利用碎石和河砂为集料制备碳化混凝土作为参比样.用质量法测定2种混凝土的碳化率分别为21.14%和10.57%;用IR法的为13.81%和16.97%.碳化后电弧熔炉钢渣集料内生长着大量簇生的犬牙状碳酸钙晶体.